Mill/drill head PF 250/BL鉆銑磨機頭 PF250/BL

Converts your lathe PD 250/E or PD 400 into a complete machining centre.將您的PD 250/E或PD 400車床改造成一個完整的加工中心。

Mill/drill head PF 250/BL

Incudes column (? 35 x 400mm), mounting bracket and fastening screws (the PD 250/E and PD 400 already come with a plane-milled surface). The lathe's top slide is replaced with the table (supplied) of 110 x 70mm, with 3 T-slots. The lathe now functions as a compound table, with X-Y travel being longitudinally and cross-wise respectively. The mill/drill head is identical to the miller FF 250/BL. Three collets of sizes 6 - 8 and 10mm are included.

NO 24 112

磨機/鉆頭PF 250/BL

插入柱（?35 x 400mm）、安裝支架和緊固螺釘（PD 250/E和PD 400已經具有平面銑削表面）。車床的頂部滑塊被替換為110 x 70mm的工作臺（提供），帶有3個T形槽。車床現在用作復合工作臺，X-Y行程分別為縱向和橫向。銑床/鉆頭與FF 250/BL銑床相同。包括三個尺寸為6-8和10mm的夾頭。

貨號：24 112

注：此處描述的車床不包括在交付范圍內。

Multiple range collet type ER-16 (DIN ISO 15488)
For FF 250/BL and PF 250/BL. One of each ? 2,4 - 3 - 3,2 - 4 and 5mm. Supplied in a wooden box with sliding lid.

ER-16型多量程夾頭（DIN ISO 15488）

適用于FF 250/BL和PF 250/BL。?2,4-3-3,2-4和5mm各一個。裝在帶滑動蓋的木箱中供應。

NO 24 146


Fine feed for accurate adjustments during milling
For FF 250/BL und PF 250/BL. Quick and easy to install. The clutch system enables feed via either the drill handle or the handwheel. The handwheel has 0.025 graduations and may be set to zero. 1 division = 0.05mm.

精細進給，可在銑削過程中進行精確調整

適用于FF 250/BL和PF 250/BL。安裝快速簡單。離合器系統可通過鉆柄或手輪進行進給。手輪有0.025個刻度，可以設置為零。1分割=0.05mm。

NO 24 140